Adhesion and quality of a plated layer depend largely on pre-treatment. Polishing, grease and oxide residues left on the surface cause stains, blistering or peeling.
Pre-treatment usually consists of ultrasonic or soak degreasing, electrolytic degreasing and activation. The right cleaner is chosen by the base material (precious metal, copper alloy, zinc die-cast, steel).
Where is it used?
- Degreasing and cleaning before plating
- Oxide removal and activation on copper and nickel
- Electropolishing of copper alloys
- Vibratory and barrel cleaning
Process steps
- Ultrasonic or soak degreasing: removing polishing and grease residues.
- Electrolytic degreasing: final cleaning and activation of the surface.
- Rinsing.
- Acid activation if needed: removing the oxide layer.
- Rinsing and transfer to the plating bath.
Safety: Cleaners and activators can be alkaline or acidic; follow the product's safety data sheet.
What we supply
- Products for pre-treatment and cleaning: listed below
- Plating chemicals: Plating processes
- Pre-treatment: Pre-treatment and cleaning
- Post-treatment: Protection and post-treatment
- Technical support for product selection and bath setup: Technical support